ESYLUX PD-C360i/24 DUODIMplus-FM Manual De Instrucciones página 19

When the "DIM" button is pressed once, the dimmer
automatically starts to slowly adjust the light intensity
of the lighting from the maximum to the minimum
value. When the required ambient brightness level
has been reached, press the "Eye" button. The new
brightness set value is then stored.
Setting the brightness set value (100 lux – 750 lux)
Acknowledgement: red and blue LEDs flash three times,
light is automatically adjusted to the set value.
Daytime operation setting (2,000 lux)
Acknowledgement: red and blue LEDs flash three times
(channel 1), no light measurement, light is only activated
by presence.
Time setting for C1 + C2 = identical!
If no further movement is detected, the time
setting starts.
1 x 15 = 15 minutes
2 x 15 = 30 minutes
Time setting for C3
If no further movement is detected, the time
setting starts.
1 x 15 = 15 minutes
2 x 15 = 30 minutes
Orientation light value 10 % - 40 % + "ON"
When pressed for the first time, the orientation
light is set to 10 %. Each further push of the button
increases the value by another 10 % until 40 % is
reached. The value then starts again at 10 %. If no
further buttons are pressed, the night-light feature
is activated.
Fade-out time for orientation light
Once the orientation light value has been set,
set the time for the afterglow feature.
Orientation light "OFF"
Offset setting for light channel C2
Light value for channel C2 is 50 %, below C1.
Offset setting for light channel C2
Light value for channel C2 is 40 %, below C1.
Offset setting for light channel C2
Light value for channel C2 is 30 %, below C1.
GB
19