Andis Sensa-Charge AGR+ Manual Del Usuario página 3

10. To disconnect remove plug from outlet.
11. WARNING: During use, do not place or leave appliance
where it may be (1) damaged by an animal or (2) exposed to
the weather.
12. Oil blades frequently. Blades may become hot during use.
13. Plug charger directly into receptacle - do not use an
extension cord.
14. Unplug charger before plugging or unplugging appliance.
15. Use of charger not sold by Andis may result in risk of fire,
electric shock, or injury to person.
16. Do not disassemble charger; take it to an Andis Authorized
Service Station when repair is required. Incorrect reassembly
may result in a risk of electric shock or fire.
17. The batteries in this clipper have been designed to provide
maximum trouble-free life. However, like all batteries, they
will eventually wear out. Do not disassemble battery pack
and attempt to replace the batteries.
18. WARNING: Keep the appliance dry.
SAVE THESE INSTRUCTIONS
OPERATING INSTRUCTIONS
• The battery is not intended to be replaced by the user.
• The battery must be removed from the appliance before it is scrapped.
• The appliance must be disconnected from the supply mains when removing the battery.
• The battery is to be disposed of safely.
CHARGING CLIPPER
1. Remove the charger from the carton and plug into an AC outlet as identified on charger unit and on
carton.
2. Place the clipper in the form-fitting pocket in the charger base (Figure A). Note that the battery pack is
fitted with a slot to align properly with the charger. Once the battery and charger are aligned, press
the battery pack firmly into the charger until it rests at the bottom of the pocket. You may hear a click
as the charging contacts engage; this is normal. The battery pack may be charged while on the
clipper, or separately. Push the battery release button (Figure B) on the clipper, and pull straight out
to remove the battery. NOTE: The battery pack is designed to run the clipper for about one hour.
A clean, sharp, well-oiled blade will provide the best run time. A busy animal shop may want an
additional battery pack, so one pack is charging while the other is running the clipper.
3. Before initial use battery pack must be charged for a minimum of one hour.
4. The charger base has two indicator lights. Below is a description of the Sensacharge light sequences
(Figure C):
CONTINUOUS GREEN LIGHT (Fast Charge) - Charger will fully charge battery pack in less than one hour.
RAPID GREEN BLINKING LIGHT (Charging Complete) - Battery pack is fully charged.
LONG GREEN BLINKING LIGHT ("Refresh") - Charger is draining battery pack in preparation for fast
charge. Please reference the section "Use of the Refresh Feature" for an explanation.
SHORT GREEN BLINKING LIGHT -
a) With Continuous Red Light (Charge Standby) - Battery pack is trickle charging because it is either
too hot or too cold to accept a fast charge. Fast charging will occur once battery pack temperature
moderates.
b) Without Red Light (Charge Preparation) - Battery pack is undergoing trickle charge, because it has
been drained excessively during use.
5. The clipper can be left in the charger base for an indefinite period of time. The charger will supply
only what is needed and will not damage the battery due to overcharge.
3