Ryobi TS1342L Manual Del Operador página 17

Sierra ingleteadora combinada con doble aislamiento
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

DANGER:
Laser radiation. Avoid direct eye contact with light source.
ALIGNING THE LASER GUIDE LINE
See Figure 13.
The laser guide will generate a colored line on the work sur-
face when the blade is spinning. The laser line will appear as
a broken line on the workpiece when the blade assembly is
in the uppermost position and the motor switch is activated.
This broken line will let you see your mark and your laser
guide line at the same time, and will assist you in lining up
your mark for more accurate cutting of the workpiece.
To Cut Your Mark:
 Using a sharp pencil, mark a line on the workpiece.
 With the saw blade in the uppermost position, align the
laser line with your mark. Once both lines are in alignment,
do not move the workpiece until after you have finished
cutting.
NOTE: As the saw blade assembly is lowered toward the
workpiece, the broken line will become solid. The solid
line will drift away from the mark as it gets closer to the
workpiece but will realign prior to the actual cut. This is
normal. NEVER attempt to move the workpiece while
making a cut. Always keep hands outside the "No Hands
Zone".
 Make several practice cuts on different styles and thick-
ness of material.
To Remove Your Mark:
Position the laser line near the left edge of your mark on
the work surface in order to remove the mark.
To Leave Your Mark:
Position the laser line near the right edge of your mark
on the work surface in order to leave the mark.
After you have become familiar with using the laser guide,
you will be able to remove, cut, or leave your mark on the
work surface. Practice will teach you the correct position for
aligning the laser line with your mark.
ASSEMBLY
BLADE BOLT
(HEX. HD)
LASER
GUIDE
BLADE
TO
LOOSEN
TO
TIGHTEN
BLADE BOLT
(HEX. HD)
17
INNER BLADE
BLADE
SCREW
BLADE
BOLT
COVER
LASER
GUIDE
FLAT(S)
ON SPINDLE
WASHER
LOWER BLADE
GUARD
Fig. 12
"NO HANDS ZONE"
LABEL
BROKEN
LINE
Fig. 13

Publicidad

Tabla de contenido
loading

Tabla de contenido