bebeduE Indra Manual Del Usuario página 12

EN
LEG REST (Fig. 11)
To lift the leg rest up, apply light upward pressure (A).
To lower it, press simultaneously on the catches underneath the leg rest, while at the same time
pushing downwards (B).
SAFETY HARNESS (Fig. 12)
The Indra pushchair comes equipped with a 5-point safety harness.
To unfasten the harness, press the central button (A).
Before fastening the harness, make sure that baby's legs are either side of the crotch strap.
Insert the tabs on the ends of the chest straps into the xture points on the side clasps. Ensure
that they are securely anchored (B).
Then introduce the side clasps into the central buckle (C).
Adjust the chest and waist straps so that they t your baby snugly.
HOW TO CHANGE THE HARNESS (Fig. 13)
The Indra pushchair is suitable for newborn babies and infants up to 15 kg. To cater for the di erence
in sizes, there are two di erent lengths of harness, which can be adjusted.
The seat comes tted with the harness in the 0 months position (A).
To change unbuckle and remove the harness chest protectors. Pass the shoulder and the waist straps
through the upper, higher slots (B).
Pull them through from the front of the pushchair (C). Next pass the shoulder and the waist straps
through the slots that are closest to the sides of the pushchair (D).
Finally, adjust the shoulder and the waist straps to t your baby and replace the shoulder
padding (E).
SAFETY BUMPER (Fig. 14)
To t the bumper, slide it into the slots in the frame until you hear a 'click' . (A).
To detach the bumper remove it from the slots by pressing the buttons underneath the bar one
at a time and removing the safety bumper (B).
FABRIC SEAT COVER SECURING STRAPS (Fig. 15)
As shown on draft you could nd a fastening strap on both sides of fabric seat cover.
Connect the strap with the snap button on the frame tube.
INSTALLATION OF THE CANOPY (Fig. 16)
· To install the canopy rst insert the hook on the extreme end of the canopy found in the
tube as outlined in the drawing (A) and attach the Velcro on the back part of the chair' s lining (B).
· Finally open the side struts until the canopy is tight (C).
· Carry out the same steps in inverse order to dismantle the canopy.
Hood with folding visor for added protection. (Fig.17)
HOW TO DISMANTLE THE OBJECT CARRIER BASKET (Fig.18)
· To dismantle the object carrier basket, unbuckle the clips as outlined in the drawing.
· Buckle-up the clips again to reassemble the basket.
Warning- Never exceed the specified weight limit, in this case 2 kg.