GYS TRIMIG 385-4S Manual De Instrucciones página 13

• Open the door on the product.
• Place the reel on the driving pin
• Tighten the nut until the reel is secure
general way, do not over-tighten.
• The wire feeder is a double groove rollers
when fitted is the diameter currently in use. For a Ø 1 wire, use the Ø 1 groove.
• For the first use:
- Release the fixing screw of the wire guide
- Place the rollers
- Then place the wire guide
screw.
• To set the adjusting knob of the pressing rollers
pressing the torch trigger, tighten the adjustment knob whilst pressing the trigger. Bend the wire where it comes out
of the nozzle and hold it in place to stop its progress. The setting is correct when the guide roller slides over the wire
even when it is blocked at the end of the torch. A common adjustment is the rollers command
steel and 2 for aluminum.
Screw the regulator/flowmeter on the gas bottle.
To avoid gas leaks, use the collars provided in the accessories box.
Possible settings:
Wire Torch
Ø 300
Steel
Ø 200
Stainless
Ø 200
Steel
Ø 300
Alu AG5
Ø 200
2T two-stage welding
4T: 4-stage welding
SPOT : Spot welding with adjustable spot
diameter
Wire speed fitting potentiometer.
The speed varies from 1 to 22 m/minute.
In 2T or 4T position, 2 modes are proposed to ease the settings of the device: MANUAL or SYNERGIC.
All manuals and user guides at all-guides.com
of the reel support
to avoid the reel inertia tangling the wire when the welding stops. In a
(Ø Ø 0,8/1 or Ø 1/ Ø1,2). The visible diameter indicated on the roller
as close as possible to the roller but without touching it, then tighten the fixing
⑬
GAS
X
Argon +
X
CO2
X
X*
Pur Argon
X*
⑪
⑫
,proceed as follow: : loosen the knob fully, start the motor by
⑬
In manual mode, the wire speed is determinated by
the user by adjusting the potentiometer
⑭
Position the potentiometer
the« OPTIMAL SYNERGIC » zone
In this mode, the device determines the optimal wire
speed according to 3 parameters:
Voltage
Wire diameter
The power mode
It is possbile to adjust the speed wire + / -.
on the scale 3 for
⑪
.
⑪
in the middle of
13