Heating A Beverage; Warming A Beverage; Preparing Tea, Camomile, Etc; Adjustments And Settings Of The Dose - Rancilio Classe 6 Serie Manual Del Usuario

8.3. Heating a beverage

● Immerse the steam spout into the liquid to be
heated.
● Gradually turn on the steam tap 6 (Fig.8); the
steam that bursts in the liquid heats it to the de-
sired temperature.
● Turn off the steam tap when the desired tempe-
rature has been reached.
Immediately after carrying out this operation,
clean the spout with a sponge or clean cloth.
Be careful as the spout is hot and may burn
your hand.

8.4. Preparing tea, camomile, etc.

● Place the jug under the hot water spout and use
the delivery control according to the model (Fig.8).
When the desired quantity has been obtained, turn
off the switch.
● Add the beverage desired.
Models E
For these models, hot water is dispensed in specific
measures (see paragraph 9, adjusting the dose of
hot water).
To dispense hot water in different quantities, proceed
as follows:
● Hold down the delivery control 4 (Fig.8) for at least
four seconds then release the button; the machine
continuously delivers water.
● When the desired measure has been obtained,
press the button E again to interrupt delivery.
When the dose of hot water is being delivered electro-
nically, delivery can be interrupted by pressing the
button 4.
When purified water is used, these beverages often
assume a darker colour.
Should the user prefer a lighter coloured drink, draw
fresh water from an ordinary tap and proceed with
the heating phase as described in point 8.3.
56
9. ADJUSTMENT AND SETTING OF THE
DOSE
9.1. Models E (Fig.8)
It is possible to adjust the dose of coffee and hot
water dispensed by electronically controlled models.
(If the function is enabled)

9.1.1. Adjusting the dose

The quantity of coffee and hot water dispensed can
be adjusted using the button panel or the hot water
controls.
1 Press the button E on any button panel and hold
it down for 8-10 seconds until water stops flowing
from the dispensing unit and the led of the conti-
nuons button on the first button panel on the left
begins flashing.
2 It is necessary to act as to make 1 or 2 cups in
order to reach the correct coffee amount adjust-
ment in the cup.
3 Put the filter-holder (with ground coffee) on the
left unit and the cup under the spout.
4 Operate the selected button (i.e. button A for one
small cup).
5 One the required coffee amount in the cup has
been reached, press the stop button A. Coffe will
stop pouring and the microprocessor will store the
dose.
6 Press the continuous button E again; the led will
go out and the machine will store the new quan-
tity.
7 Make the coffee and check the cup amount in
order to check that programming is correct.
If some doses have to be changed (A-B-C-D), once
at point 5 repeat the instructions in points 3-4-5 for
each dose, remembering to use the filter-holder with
relevant filter and freshly ground coffee.
Then carry out point 6 and repeat point 7 to check
all changed doses.
If all units are to be programmed with the same
doses, the selection of coffee doses is finished. If
the dosage of another unit is to be changed (1-2-3-4
doses), proceed as indicated in the above-mentio-
ned point 1-7, using only the button panel of the
selected unit.