Glass Shelves - Haier H3R-330WNA Manual Del Usuario

[ «-)
Energy saving tips
Make sure the appliance is properly ventilateci (refer to INSTALLATION section).
►
Do not install the appliance in direct sunlight or in the near of heat sources
►
(e.g.stoves, heaters).
Avoid unnecessarily low temperature in the appliance. The energy consumption
►
in creases the lower the temperature in the appliance is set.
Allow warm food to cool down before placing it in the appliance.
►
Open the appliance door as little and as briefly as possible.
►
Make sure the door always closes correctly and unimpaired by food position.
►
Keep door seals clean.
Clean the rear of the appliance regularly. Dust increases energy consumption.
►
The most energy-saving configuration requires drawer, food box and shelves to
►
be positioned in the appliance on factory-fresh condition, and food to be
placed without blocking the air outlet of the duct.
7 - Accessory
I J <D (jjl
I
I@
14
7.1 Removable door racks
7. 1
The door rack can be removed for cleaning:
Piace hands on each side of the rack, lift it upwards (1)
and pull it out (2) (Fig. 7.3).
In arder to insert the door rack, the above steps are
carried out in reverse arder.

7.2 Glass shelves

7. 2
1. To take out a shelf,remove it first by uplifting its hind
edge (1) and pulling it out (2) (Fig. 7.2).
2. To reinstall it, put it on the lugs on both sides and
push it to the most rearward position until the rear
of the shelf is fixed inside the slots in the sides.
EN