Kohler STERLING 3190A Serie Guia De Instalacion página 5

2. Mark and Drill the Mounting Holes
With the slots in the wall jamb toward the inside of the shower, place the bottom end of the wall
jamb against the bottom "C" frame.
Align the outside edge of the wall jamb with the mark made on the bottom "C" frame.
Using a level, plumb the wall jamb.
Mark the three wall mounting holes with a pencil.
Remove the "C" frame from the shower ledge.
IMPORTANT! For ceramic tile walls, use a center punch to lightly punch the three hole locations for the
wall jamb before drilling.
NOTE: Select the appropriate drill bit based upon the wall material. For ceramic tile walls, use a 3/16"
masonry drill bit. For fiberglass walls, use a 5/16" drill bit.
Slowly drill at the marked hole locations.
Thoroughly clean the ledge and wall of debris.
Insert the hollow wall anchors into the drilled holes.
Repeat the above procedure for the remaining wall jamb.
Place the bottom "C" frame back on the shower ledge.
Sterling
Slots Toward Inside
of Shower
Pencil
Wall Jamb
Level
Bottom "C" Frame
Shower Base
5
Wall Jamb
1034048-2-B