Problems And Solutions - ALZA Orbit Manual De Instrucciones

PROBLEMS AND SOLUTIONS

PROBLEM
Heating for a
regulator valve has a
sound, but no steam
comes out.
The steam emit from
safety valve.
The steam emit from
around area.
MAINTENANCE
1) Cooker body
Use detergent to clean dirty areas
Dry the cooker.
Don't touch the cooker body directly with the metal tool.
Don't let the cooker touch the iron-related metal.
2) Silicone gasket
Use detergent to clean impurities on the lid. Dry up the gas-
ket totally.
Install the gasket in the proper position.
Use detergent or water to wash the gasket after used. After
drying up the gasket, put it in the proper position in the lid
and keep it flat. Replace the original gasket after long time
used.
3) Regulator valve, vent-pipe, safety valve
If the regulator valve, vent-pipe and safety valve jammed re-
sidual foods and other things, use small stick to clean and
make sure the water pass fluently. Please check the screw cap
flexible or not, if flexible, reassemble again.
Every time after using, should clean the regulator, it will be
easy to pull the control valve directly to clean with flowing
water.
4) Remove the scorched matters
Use soft wood products to remove.
If the scorched matters are sticky enough let the cooker in
hot water for a while and remove the scorched matters. Not
get rid of with sharp tools.
CAUSE
1) The regulator valve blocked.
2) Food remains in the Ventilator of open
area.
3) Dry heating.
4) The cooker declined.
1) The ventilator hole blocked.
2) There is much food inside.
3) Flame is too strong.
1) The regulator valve and safety valve they
do not work properly.
2) The gasket laid incorrectly.
3) The gasket was destroyed.
4) The gasket is not clean.
5) The lid is not locked fully.
IMPROVE METHODS
1) Get rid of the matter.
2) Remove with needle.
3) Switch off, put the cooker flat and let the con-
trol valve incline to release pressure, then open
the lid to check.
4) Put the cooker on flat.
1) Get rid of matters.
2) Get rid of part food.
3) Use middle fire to heat, adjust the control
valve and choose suitable pressure.
1) Remove with needle.
2) Laid the gasket in correct position.
3) Replace a new gasket.
4) Clean the gasket.
5) Lock the lid properly.
5) Maintenance
Clean the body and lid. Get the gasket out for cleaning.
Use small stick to remove the scorched matters in the control
valve, vent-pipe and safety valve and some smell.
Please put it in the dry places.
Please keep the cooker body and lid separately.
Special notice
Don't use frictional washing articles.
Don't wash the cooker lid in the washing machine.
Lay edible oil on the gasket to extend the life and better the
performance.
Don't lock the lid after used or the gasket will not work.
Defrost the frozen goods before cooking. Wash the bean or
dry food in advance.
Open the lid first when cooked the easy bubble food. when
the bubble removed close the lid to cook..
It is hard to lose water while long cooking is another thing.
Turn down the heat resource if the soup overflows.
6) Replacement
Gasket is replaced once every two years. If damage, crack or
crinkle please replace immediately.
Never use substitute when you replace the components.
please contact the original supplier immediately.