Install The Software And Connect The Scanner; Install The Software First (Windows And Macintosh); Connect The Scanner First (Windows Only) - HP scanjet 2300c Serie Manual Del Usuario

install the software and connect the scanner

Set up your scanner in one of two ways: either install the software first or connect
the scanner first. It is recommended that you install the software first, especially
on a Macintosh computer.
install the
1
software first
2
(Windows and
Macintosh)
3
4
5
6
7
connect the
1
scanner first
(Windows
2
only)
install the scanner
If you experience difficulty installing your scanner, see
problems - hp scanjet 2300c or 3500c series
Close all open programs on your computer.
Locate the HP Photo & Imaging software CD-ROM that is appropriate for
your English and operating system and insert it into your computer.
For a Microsoft Windows computer: Follow the instructions on the screen.
Or, if the installation program does not start automatically:
a. On the Start menu, click Run.
b. Type: x:setup.exe (where x is the letter of the CD-ROM drive).
For a Macintosh computer (HP Scanjet 3500c series only): Double-click the
Installation Read Me file on the CD-ROM and follow the instructions.
If the instructions prompt you to shut down your computer, do so.
Connect the USB cable between the USB port on the scanner and the USB
port on the computer.
Connect the power cable between the scanner and a surge protector or a
grounded wall outlet that is easy to reach. This turns on the scanner.
If necessary, turn your computer on again.
connect USB cable to scanner
Make sure that your computer is on and that the operating system is
running.
Connect the USB cable between the USB port on the scanner and the USB
port on the computer.
installation
on page 11
connect USB cable to computer
.
2