ASBER G-OEM-500 Instrucciones De Instalación, Uso Y Mantenimiento página 39

EN
Quick guide
G / OEM-500
Operations
Filling and heating
1. Turn control button (1) to select the required cycle time. The pilot lamp will
light up (2).
2. Wait until the machine reaches the correct operating conditions and the pilot
lamp lights up (3).
Wash
1. Remove scraps from tableware before inserting plates in the dishwasher.
2. Open door, insert tableware, close door.
3. Press the cycle start button (4) which will light up and remain lit until the end
of the cycle.
4. Repeat process when cycle ends.
Cleaning products
The detergent and rinse aid dispensers are standard.
(Please refer to user manual for details on the adjustment and operation of the
THE DETERGENT SHOULD BE INDUSTRIAL, HIGH TEMPERATURE,
NON-FOAMING LIQUID DETERGENT
dispensers)
Fig.1
1 2
Drainage and cleaning
Drainage
1. Turn control button (1) to position "0" (OFF) (Fig. 1).
2. Open the door and remove the overflow (Fig. 3).
DO NOT REMOVE THE FILTER OR LOSE THE O-RING
3. Close the door, turn the control button (1) to the drainage position
4. Press the cycle start button (4) which will light up and remain lit until the end of
the cycle (Fig. 1).
5. Omit steps 3 & 4 in models with gravity drainage
6. Turn control button (1) to position "0" (OFF) (Fig. 1).
Cleaning
1. Open the door, remove the filter (Fig. 4) and all the filter trays for cleanning.
2. Clean and dry the machine with soft cloth. Leave the door open until the next
day or next start-up
3. Replace the filter, the overlow with the O-ring and al the filter trays.
Descaling
1. Insert descaler in the tub and run as many cycles as necessary.
(Please see user manual for further details of this operations)
39
3
4
(Fig. 1)