ASBER G-OEM-500 Instrucciones De Instalación, Uso Y Mantenimiento página 41

EN
Quick guide
G / T-OEM-500
Operations
Filling and heating
1. Close the door, push button (1). The led inside the button (1) will light.
2. Wait until the machine reaches the correct operating conditions. The rinse
temperature (3) must be at least 85°C and the tank temperature (4) should be
at least 55°C.
Wash
1. Remove scraps from tableware before inserting plates in the dishwasher.
2. Open door, insert tableware, close door.
3. Select cycle by pressing button (5), (6) or (7). The leds inside the cycle start
button, indicate the machine is running.
4. Repeat process when cycle ends.
Notes:
To speed up the heating process, run a couple of each of the cycles only after
the rinse temperature has reached 85
If you start the cycle before the rinse cycle has reached a minimum temperature or
85°C.
THE WASH CYCLE MAY TAKE LONGER.
Cleaning products
The detergent and rinse aid dispensers are standard.
(Please refer to user manual for details on the adjustment and operation of the
THE DETERGENT SHOULD BE INDUSTRIAL, HIGH TEMPERATURE,
NON-FOAMING LIQUID DETERGENT
°C.
dispensers)
Fig.1
1 2
Drainage and cleaning
Drainage
1. While the machine is turned on, open the door.
2. Remove the filters (Fig. 2) and the overflow (Fig. 3).
DO NOT REMOVE THE FILTER OR LOSE THE O-RING
3. Close the door, push the button (5) for 3 seconds to run drainning. The led light
inside the button (5) starts blinking
4. Wait until the (5) button led light off.
5. Omit steps 3 & 4 in models with gravity drainage
6. Push button (1) to switch off the machine and close the door.
Regeneration
1. Regeneration cycle in SOFT models must be done after the draining cycle.
Machine must be empty.
2. If the LED (2) is on, fill the can of salt inside the device.
3. Open the door.
4. Push button (6) during 3 seconds.
5. Once the led light inside the button (6) starts blinking, close the door.
6. Wait until the (6) button led light off.
7. Clean internal part of machine
Cleaning
2. Open the door, remove the filter (Fig. 4) and all the filter trays for cleaning.
3. Replace the filter, overflow with O-ring and all the filter trays.
4. Clean and dry the machine with a soft cloth. Leave the door open until the next
day or next time the machine is used.
Descaling
1. Insert descaler in the tub and run as many cycles as necessary.
(Please see user manual for further details of this operations)
41
6 7
3 4 5