Sauder Office Port 408289 Manual Del Usuario página 11

Step Step 6
Separate the EXTENSION SLIDES (40MC) from the EXTENSION RAILS (40MA) as shown in the upper diagram below. Be
å
prepared, the parts are greasy.
Fasten the EXTENSION RAILS (40MA) to the EXTENSION BLOCKS (I) on the ENDS (A3 and B3) and UPRIGHTS (C3 and
å
D3). Use eight GOLD 5/16" FLAT HEAD SCREWS (3S) through holes #1 and #3.
NOTE: Use the exact holes shown.
å
NOTE: For each EXTENSION RAIL, turn a SCREW into the hole shown in the enlarged diagram. Then, slide the inner
å
cartridge of the EXTENSION RAIL out to fi nd the other hole that lines up with the hole in the EXTENSION BLOCK. Turn a
SCREW into this hole.
Push the black lever in and pull the SLIDE from the RAIL.
Open end
Hole
www.sauder.com/services
40MC
A3
D3
4
3
2
1
I
Open end
GOLD 5/16" FLAT HEAD SCREW
(8 used in this step)
1
2
3
4
I
C3
B3
4
3
2
1
I
3S
408289
40MA
Open end
Open end
1
2
3
4
I
Page 11