Sauder Office Port 408289 Manual Del Usuario página 23

Step Step 18
1
D87
T
Groove
Insert the LARGE DRAWER SIDES (D87 and D88)
å
at an angle into the slot at each end of the LARGE
DRAWER FRONT (T).
3
Fasten the LARGE DRAWER BACK (D78) to the LARGE DRAWER SIDES (D87 and D88). Use four BLACK 1-9/16" FLAT
å
HEAD SCREWS (30S).
NOTE: Be sure the LARGE DRAWER BOTTOM (D708) inserts into the groove of the LARGE DRAWER BACK (D78).
å
Repeat this step for the remaining drawers.
å
www.sauder.com/services
The tabs should insert freely
into the slots. Gently tilt the
DRAWER SIDES side to side
until the tabs slip into the slots.
D88
D78
D87
D708
VIEW THE T-LOCK BOX VIDEO
2
D87
Be sure the DRAWER
BOTTOM inserts into the
DRAWER FRONT groove.
Slide the LARGE DRAWER BOTTOM (D708) into the
å
grooves in the LARGE DRAWER SIDES (D87 and D88)
and LARGE DRAWER FRONT (T).
Start each screw a few turns before
completely tightening any of them.
BLACK 1-9/16" FLAT HEAD SCREW
D88
408289
With the palm of your
hand, tap the DRAWER
BOTTOM down into
U n
the groove.
fi n
s u
i s h
r f a
e d
c e
D708
D88
T
30S
(24 used in this step)
Page 23