Safety Instructions - Flex L 3309 FRG Instrucciones De Funcionamiento Originales

Safety instructions

WARNING!
Read all safety instructions and other
instructions. Failure to observe the safety
instructions and other instructions may
result in an electric shock, fire and/or
serious injuries. Save all warnings and
instructions for future reference.
L 3309 FRG only:
This electric power tool must be used as

a grinder and cut-off grinder. Read all
safety warnings, instructions, illustrations
and specifications provided with this
power tool.
Failure to follow all instructions listed
below may result in electric shock, fire and/
or serious injury.
Operations such as sanding, wire

brushing or for polishing are not
recommended to be performed with this
power tool.
Operations for which the power tool was
not designed may create a hazard and
cause personal injury.
L 3406 VRG only:
This electric power tool must be used as

a grinder, sander, polisher, wire brush and
cut-off grinder. Read all safety warnings,
instructions, illustrations and specifi-
cations provided with this power tool.
Failure to follow all instructions listed
below may result in electric shock, fire and/
or serious injury.
Do not use accessories which are not

specifically designed and recommended
by the tool manufacturer.
Just because the accessory can be
attached to your power tool, it does not
assure safe operation.
The rated speed of the accessory must

be at least equal to the maximum speed
marked on the power tool.
Accessories running faster than their rated
speed can break and fly apart.
The outside diameter and the thickness

of your accessory must be within the
capacity rating of your power tool.
Incorrectly sized accessories cannot be
adequately guarded or controlled.
14
The arbour size of wheels, backing pads

or any other accessory must properly fit
the spindle of the power tool.
Accessories with arbour holes that do not
match the mounting hardware of the
power tool will run out of balance, vibrate
excessively and may cause loss of control.
Do not use a damaged accessory.

Before use, always check insertion tools
for splinters and cracks, sanding pad for
cracks, wear and severe abrasion.
If power tool or accessory is dropped,
inspect for damage or install an
undamaged accessory. After inspecting
and installing an accessory, position
yourself and bystanders away from the
plane of the rotating accessory and run the
power tool at maximum no-load speed for
one minute.
Damaged accessories will normally break
apart during this test time.
Wear personal protective equipment.

Depending on application, use face shield,
safety goggles or safety glasses.
As appropriate, wear dust mask, hearing
protectors, gloves and shop apron
capable of stopping small abrasive or
workpiece fragments.
The eye protection must be capable of
stopping flying debris generated by
various operations. The dust mask or
respirator must be capable of filtrating
particles generated by your operation.
Prolonged exposure to high intensity noise
may cause hearing loss.
Keep bystanders a safe distance away

from work area. Anyone entering the work
area must wear personal protective
equipment.
Fragments of workpiece or of a broken
accessory may fly away and cause injury
beyond immediate area of operation.
Hold power tool by insulated gripping

surfaces only, when performing an
operation where the cutting accessory
may contact hidden wiring or its own cord.
Cutting accessory contacting a "live" wire
may make exposed metal parts of the
power tool "live" and shock the operator.
Angle grinder