Publicidad
Idiomas disponibles
Idiomas disponibles
When working, guide the electric power
tool with both hands. The handle must be
attached! Do not switch on the machine
until both hands are in the grip position.
Keep hands away from the running
sanding belt. There is a risk of injury
caused by crushing in the area of the guide
rollers. On account of the operating mode
and the guaranteed flexibility of the power
tool these danger areas cannot be
completely shielded.
Dust released from materials, such as lead
paints, some types of wood, minerals and
metal, may be hazardous to the operator or
people in the vicinity. Inhaling or touching
these dusts may result in respiratory
diseases and/or allergic reactions.
– Ensure the work place is well ventilated!
– If possible, use external dust extraction.
– It is recommended to wear a respirator
mask belonging to filter class P2.
Do not work on materials which release
hazardous substances (e.g. asbestos).
Never grind or cut light metals which have
a magnesium content greater than 80%.
Risk of fire!
If power tools are used outdoors or are
exposed to excessive amounts of metal
dust, connect them via a residual-current-
operated circuit-breaker (tripping current
maximum 30 mA). Do not use any worn,
torn or severely clogged sanding belts.
Damaged sanding belts may rip, fly off and
cause an injury.
Before using the machine, check that the
grinding tools have been installed and
secured correctly. Switch on the machine
at no load for 30 seconds!
Interrupt the test run immediately if violent
vibrations occur or other damage is estab-
lished. Check the machine to determine
the cause.
Do not load electric power tool to such an
extent that it comes to a standstill or the
sanding belt slips.
Before putting down the electric power
tool, switch it off and wait until it comes to
a standstill.
12
Do not clamp the electric power tool in
a vice.
Always lay the power cord to the rear away
from the electric power tool.
Clamp the workpiece if it is loose or not
positioned securely by its own weight.
Store and handle grinding tools according
to the manufacturer's instructions.
Additional safety instructions
Use only extension cables permitted for
outdoor use.
Identify the power tool with stickers only.
Do not drill any holes into the housing.
The mains voltage and the voltage
specifications on the rating plate must
correspond.
Noise and vibration
The noise and vibration values have been
determined in accordance with EN 60745.
The A evaluated noise level of the power tool
is typically:
– Sound pressure level L
– Sound power level L
– Uncertainty K:
Total vibration value (of the handle):
– Emission value a
– Uncertainty K:
WARNING!
The indicated measurements refer to new
power tools. Daily use causes the noise and
vibration values to change.
NOTE
The vibration emission level given in this
information sheet has been measured in
accordance with a standardised test given in
EN 60745 and may be used to compare one
tool with another. It may be used for
a preliminary assessment of exposure.
The declared vibration emission level
represents the main applications of the tool.
However if the tool is used for different
applications, with different accessories or
poorly maintained, the vibration emission may
differ. This may significantly increase the
exposure level over the total working period.
FBE 8-140
:
80 dB(A);
pA
:
91 dB(A);
WA
:
< 2.5 m/s
h
1.5 m/s
3 dB.
2
2
Publicidad
Capítulos
