Troubleshooting - Kobalt SGY-AIR225 Manual Del Usuario

TROUBLESHOOTING

PROBLEM POSSIBLE PROBLEM
1. Grit or gum in tool.
2. No oil in tool.
3. Low air pressure.
Tool runs
4. Air hose leaks.
slowly or will
not operate.
5. Pressure drops.
6. Moisture blowing
out of tool exhaust.
CORRECTIVE ACTION
1. Flush the tool with air-tool oil or gum
solvent.
2. Lubricate the tool.
3. Adjust the compressor regulator to
tool maximum of 90 PSI.
4. Tighten and seal hose fittings if
leaks are found. Use sealing tape.
5. a. Be sure the hose is the proper size.
Tool using large volumes of air may
require a hose with an I.D. of 1/2 in.
or larger depending on the total
length of the hoses.
b. Do not use a multiple number of
hoses connected together.
6. Water in tank; a. drain tank. (See air
compressor manual). b. Oil tool and
run until no water is evident. Oil tool
again and run 1-2 seconds.
14