Operating Instructions - Kobalt SGY-AIR225 Manual Del Usuario

ASSEMBLY INSTRUCTIONS
6. Connect the air hose to the male plug. Set
the working pressure at 90 PSI for best
tool performance (See Figure 6).
NOTE
Working pressure is the amount of air
pressure the tool sees when operating.
DISASSEMBLY INSTRUCTIONS
1. To remove the chisel, hold onto the
bottom hook on the retaining spring and
turn the spring counterclockwise or you
can insert a screwdriver into the hook to
help turn the spring (See Figure 6).
2. Refer to assembly instructions to install a
different chisel.

OPERATING INSTRUCTIONS

1. Press the trigger (D) to start the tool
(See Figure 1).
NOTE
Always be cautious of your hands and
finger placement while tool is running.
Always disconnect air supply when not
in use to prevent accidental firing of
the tool.
6
7
Top hook
Counterclockwise
1
D
12
E
I
B
Bottom hook
D