Publicidad
Step 14
1
D24
Groove
Insert the SMALL DRAWER SIDES (D24 and D25)
å
at an angle into the slot at each end of the SMALL
DRAWER FRONT (L2).
3
M67
Surface with
HIDDEN CAM
Fasten the DRAWER BRACE (M67) to the SMALL
å
DRAWER FRONT (L2). Tighten one HIDDEN CAM.
www.sauder.com/services
The tabs should insert freely
into the slots. Gently tilt the
DRAWER SIDES side to side
until the tabs slip into the slots.
D25
L2
Maximum
Arrow
210 degrees
Minimum
190 degrees
L2
VIEW THE T-LOCK BOX VIDEO
2
With the palm of your hand, tap the
DRAWER BOTTOM down into the groove.
U n
fi n
s u
i s h
r f a
e d
c e
D24
Be sure the DRAWER
BOTTOM inserts into the
DRAWER FRONT groove.
Slide the DRAWER BOTTOM (D945) into the grooves in
å
the SMALL DRAWER SIDES (D24 and D25) and SMALL
DRAWER FRONT (L2).
4
Start each screw a few turns before
completely tightening any of them.
BLACK 1-9/16" FLAT HEAD SCREW
D24
M67
Fasten the SMALL DRAWER BACK (D170) to the SMALL
å
DRAWER SIDES (D24 and D25) and DRAWER BRACE (M67).
Use five BLACK 1-9/16" FLAT HEAD SCREWS (30S).
Repeat this step for the LARGE DRAWERS.
158015
D945
D25
L2
30S
(25 used in this step)
D170
Be sure the
D25
DRAWER
BOTTOM
inserts into
the DRAWER
BACK groove.
Page 19
Publicidad
