Xerox GBC Fusion Punch II Guia Del Usuario página 53

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 662
5
Slide a sheet of tab stock or cover stock partially through the Die.
6
Ensure that the stock is against the Document Transport Guide Rail, as
shown in Figure 2-8. If the stock is straight against the Document
Transport Guide Rail and as close as possible to the Side Guide without
actually touching it, go on to Setting the Backgauge. If the Side Guide
is not as close as possible to the stock without touching it, go on to
Step 7 to adjust the Side Guide.
Side Guide
Retaining Screw
Infeed Guide
(Teflon® Plastic
Piece)
Cover Stock
7
If punching the 11" edge of the sheet, loosen the Side Guide Retaining
Screw. If punching the 8.5" edge of the sheet, add the additional Short
Edge Side Guide to the Sheet Eject Strap assembly with the adjustment
screws finger tight. Remove the stock and close the Sheet Eject Strap
assembly. Now, slide the stock under the Sheet Eject Straps and
partially through the Die again.
Note: When using the existing 11" Side Guide, ensure that the Side Guide
is under the Infeed Guide (Figure 2-8) before continuing.
Teflon® is a registered trademark of E.I. du Pont de Nemours and Company.
2-10
Figure 2-8: Adjusting the Side Guide
Side Guide
Document
Transport
Guide Rail
General Procedures

Publicidad

Tabla de contenido
loading

Tabla de contenido