Xerox GBC Fusion Punch II Guia Del Usuario página 70

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 662
To lower the Stacker Tray for unloading, go to the FusionPunch II Control
Panel and do the following:
1
If in Cycle Up mode:
and only one stacker is installed, wait for the FusionPunch II and
n
the host printer to cycle down. GBC Fusion Full Stop will be
displayed in the LCD Display Screen when the machines have
cycled down.
and the system is equipped with a Second Offset Stacker, you will
n
not have to wait for the the punch and the printer to cycle down. By
setting the destination to Stack 1 or Stack 2 the FusionPunch II
will automatically switch between the stackers as long as the next
stacker's tray is in the up position.
2
Press the Raise/Lower Stacker
first (#1) Stacker in the system.
Press the Raise/Lower Stacker
second stacker in the system (if a second Stacker is installed).
3
Open the Stacker Door and remove the punched copy.
4
Close the Stacker Door.
5
Press the Raise/Lower Stacker
(or trays) back up to the top position. The Punch will not start with the
Stacker tray(s) down. The following applies to Stackers:
If a single Stacker is used and its tray is down, the Punch Control
n
Panel will display a message telling you to empty the Stacker. The
Punch will not start until the tray is up.
If more than one Stacker is employed in the system, at least one of
n
the Stackers' trays must be up to start the Punch. However, when
that Stacker fills up, the Punch will not switch to the other Stacker
if its tray is down. Instead, it will stop the Printer and display a
message telling you to empty the Stacker.
Using the GBC Stacker
#1 button to lower the tray of the
#2 button to lower the tray of the
button(s) to raise the Stacker tray
2
2-27

Publicidad

Tabla de contenido
loading

Tabla de contenido