Xerox GBC Fusion Punch II Guia Del Usuario página 64

3
Click on the On-line Finishers tab. The window will display as shown
below.
4
Verify that the profile for the Downstream device to be used is
Enabled.
For punching and stacking the 11" edge in the Xerox High Capacity
l
Stacker, ensure the HCS profile is Enabled.
For punching and stacking the 8.5" edge, ensure the GBCSE
l
profile is Enabled.
For all other applications, ensure the profile that associates with the
l
Downstream device to be run is Enabled.
(In the figure above is an example of a job being sent to a Signature
Booklet Maker.) If this profile is not visible in this window,
go to step 8. If this profile is visible but not Enabled (green check-mark
in the Enabled column), highlight the profile and click Enable and then
click Close.
Starting a Job
Figure 2-19: On-line Finishers tab
On-line
Finishers
Tab
2
2-21