ATH-Heinl ATH-M M72Z Plus Manual De Usuario página 72

1.3.4 Setting up the assembly head
If you are predominantly processing large wheels up to 24" or small 8" wheels, it is
advisable to adapt the assembly head settings to the wheel rim diameter.
® Copyright ATH-Heinl GmbH & Co. KG, All rights reserved / Misprints and technical changes reserved / As of: 2021-04
Tip and/or swivel the assembly head into the working position
and release the locking device in order to bring the assembly
head up to the rim flange by hand and put it on.
The front plastic abrasive may touch the respective rim contour
When locking the assembly head, this automatically moves away
from the wheel rim in height and distance.
Manufacturer ATH-Heinl GmbH & CO.KG
- 15 -
.