ATH-Heinl ATH-M M72Z Plus Manual De Usuario página 78

1.3.7 Inflating tyres
The maximum tyre pressure may not exceed 3.5 bar.
All parts of the body should be kept away from the tyre.
During operation the noise level can reach 85 dB (A), so the operator should take
appropriate protective measures.
® Copyright ATH-Heinl GmbH & Co. KG, All rights reserved / Misprints and technical changes reserved / As of: 2021-04
Start the rotational movement of the clamping plate.
During the assembly process, ensure that the bead run is correct.
Failing to ensure this can cause serious damage to the tyre.
!!! ATTENTION never try to press down the tire with the pneumatic
assembly finger. This can damage the assembly head !!!
In order to complete the process, release the wheel rim clamp to
remove the wheel.
Ensure that the tyre has been fully lubricated.
Start the inflation process.
If the air volume of the tyre inflator is not sufficient to push the tyre
over the wheel rim, you can increase the air volume by removing the
inner valve. This must be replaced quickly afterwards.
Ensure that the tyre has been inflated to the correct pressure.
Consult the manufacturer's specifications to establish this.
If the tyre pressure is too low, this can lead to increased wear and
decrease the service life of the tyre. The inside of the tyre can also
be damaged.
The tyre pressure must be checked once a week.
Only check the tyre pressure at normal tyre temperatures (i.e. the
vehicle has not been driven for more than an hour and not more
than 2-3 km)
Manufacturer ATH-Heinl GmbH & CO.KG
- 21 -