The Camera Control Panel - Optika Italy H Serie Manual De Instrucciones

10.1 The Camera Control Panel

The Camera Control Panel controls the camera to achieve the best image quality according to the specific applications.
It will pop up automatically when mouse cursor is moved to the left side of the video window (in measurement status, the
Camera Control Panel will not pop up. Only when measurement process is terminated will the Camera Control Panel pop
up by moving mouse cursor to the left side of the video window).
Left-clicking button to enable Display / Auto Hide switch of the Camera Control Panel.
Control Panel Function
Snap Capture image from the current video window
Record Record video from the current video window
Auto Exposure When Auto Exposure is checked, the system will automatically adjust
exposure time according to the value of exposure compensation
Exposure Available when Auto Exposure is selected. Slide left or right to adjust
Compensation the exposure compensation according to the current video brightness
to get the correct brightness value.
Exposure Time Available when Auto Exposure is unchecked. Slide to left or right to re-
duce or increase exposure time, adjusting brightness of the video
Gain Adjust Gain to reduce or increase brightness of video. The Noise will be
reduced or increased accordingly
Red Slide to left or right to decrease or increase the proportion of Red in
RGB on video
Green Green is base for reference and cannot be adjusted
Blue Slide to left or right to decrease or increase the proportion of Blue in
RGB on the video
White Balance Adjusting the White Balance according to the monitor display
Sharpness Adjust Sharpness level of the video window
Denoise Adjust Noise level of the video window
Saturation Adjust Saturation level of the video window
Gamma Adjust Gamma level of the video. Slide to the right side to increase
gamma and to the left to decrease gamma
Contrast Adjust Contrast level of the video. Slide to the right side to increase
contrast and to the left to decrease contrast
DC For DC illumination, there will be no fluctuation in light source so no
need for compensating light flickering
AC(50HZ) Check AC(50HZ) to eliminate flickering "strap" caused by 50Hz illumi-
nation
AC(60HZ) Check AC(60HZ) to eliminate flickering "strap" caused by 60Hz illumi-
nation
Default Set all the settings in the Camera Control Panel to default values
Description
Page 16