On-Board Charger - Cushman TITAN XD Manual Del Propietário

Read all of this manual to become thoroughly familiar with this vehicle. Pay particular attention to all Notices, Cautions, Warnings, and Dangers.
Before a new vehicle is put into operation, the items shown
in the INITIAL SERVICE CHART must be performed.
The vehicle batteries must be fully charged before initial
use.
Check for leaks that could have developed in shipment
from the factory.
Check for correct tire inflation. See GENERAL SPECIFI-
CATIONS.
Check the operation of the vehicle brakes, including the
parking brake, make adjustments if necessary. Check the
hydraulic brake fluid level in the master cylinder.
Remove the protective clear plastic from the seat bottom and back rest before placing the vehicle in service

ON-BOARD CHARGER

Risk of electric shock. Connect charger power cord to an outlet that has been properly
installed and grounded in accordance with all local codes and ordinances. A grounded
outlet is required to reduce risk of electric shock – do not use ground adapters or modify
plug. Do not touch uninsulated battery terminal.
Do not open or disassemble charger. Do not operate charger if the AC supply cord is
damaged or if the charger has received a sharp blow, or otherwise damaged in any way –
refer all repair work to qualified personnel. Not for use by children.
To prevent a physical hazard that could result in an electrical shock or electrocution, be sure that
the charger plug is not damaged and is inserted fully into a grounded receptacle.
The power (AC) cord is equipped with a grounded plug. Do not attempt to pull out, cut or bend
the ground post.
Never charge the vehicle in a hazardous environment.
The on-board charger is located under the cargo deck at
the rear of the vehicle, it is wired directly to the batteries.
Before charging the batteries park the vehicle in a well
ventilated area, set the parking brake, turn the key switch
to OFF and remove the key. Pull charger out the charger
cord and plug into a dedicated 15 amp AC outlet to start
the charger.
When the charging cycle is complete, disconnect the char-
ger cord and replace it in the storage area provided.
OPERATING PROCEDURES
ITEM
Batteries
Seats
Brakes
Tires
SERVICE OPERATION
Charge batteries
Remove protective plastic covering
Check operation, adjust if necessary
Check hydraulic brake fluid level
Check air pressure (see SPECIFICATIONS)
INITIAL SERVICE CHART
Battery Charger
and Cord Storage
4
4 - 3