Tabla de contenido
Publicidad
WARNING
Disconnect the electrical supply before servicing or cleaning the vacuum cleaner.
Failure to do so could result in electrical shock or personal injury from vacuum
cleaner suddenly starting.
Review this chart to find do-it-yourself solutions for minor performance problems.
Any service needed, other than those described in these Operating Instructions,
should be performed by an authorized service representative.
PROBLEM
Vacuum Cleaner
won't run.
Poor job of dirt
pick-up.
Agitator not turning.
BEFORE REQUESTING SERVICE
Electrical Shock or Personal Injury Hazard
POSSIBLE CAUSE
1. ON/OFF button not turned on.
2. Battery is dead.
1. Full or clogged dust bin.
2. Dirty filters.
3. Clogged nozzle or dust bin.
4. Overload proctector activated.
5. Worn agitator.
1. Overload proctector activated.
2. Belt/agitator not installed
properly.
1. Push ON/OFF button to on.
2. Charge Battery
1. Empty dust bin.
2. Change/clean filters.
3. Clean nozzle or dust bin.
4. Turn off for 10 seconds, and
5. Replace agitator.
1. Turn off for 10 seconds, and
2. Check belt and/or agitator.
- 28 -
POSSIBLE SOLUTION
then turn back on.
then turn back on.
Publicidad
Tabla de contenido
