Tabla de contenido
Publicidad
Sicherheitshinweise
Safety information
Indicaciones de seguridad
Consignes de sécurité
Improper usage
Too much load may not be placed
on the drives (maximum load 50 kg
and evenly distributed) – otherwise
this can cause injuries to people or
damage to the product.
Don't use the table to lift people.
Don't sit or stand on the table while
operating it (because of the risk of
injury).
Only use the table indoors.
Operating products with double
or thicker insulation:
Protection class II
Protection class II equipment has
thicker or double insulation
between the mains circuit and
output voltage or metal housing
and usually isn't connected to the
protective conductor. This
measure is also called protective
insulation (safe electrical separa-
tion). Even if it has electrically
conductive surfaces, it is protec-
ted from contact with live compon-
ents through the thicker insulation.
As a protection class II device,
Timetable Lift doesn't require a
safety plug; plugs are used that
don't have a protective contact.
In Europe, equipment with thicker
or double insulation must be
labelled with the Protection Class
II symbol (a square within a
square).
You'll find this label on the control
unit (see page 39), which is located
on the underside of the table top.
Spare parts for double-insulated
products must be identical to the
products replaced.
You may only use detergents and
disinfectants with a pH value of
6 to 8 (i.e. no very alkaline or acidic
agents).
Packaging and shipping
the battery
Before unpacking the product,
please check the packaging for
damage to prevent injuries.
Damaged batteries must be
disposed of as outlined in these
instructions for the BA001 and by
local regulations.
General safety information
for the BA001 battery
Only the CBD6S motorized control
integrated into the table and the
SMPS006 charger supplied with
the battery may be used for
recharging the BA001.
Please note that the battery or the
charger can get hot when charging
or discharging. Keep both away
from flammable objects.
Keep the charger and batteries
away from children. Each battery
must be placed on an inflammable
base.
If batteries are damaged, they
must be removed and replaced
immediately in order to prevent
hazards and malfunctions.
The BA001 must not be exposed to
heat or naked flames. Avoid any
contact with water or direct
sunlight.
Don't cover the charger or battery
while charging.
Don't use the batteries if you
notice any smoke forming.
The BA001's capacity will decrease
over time. This decrease in capa-
city depends on usage and tempe-
rature. In ideal conditions, the
discharge capacity is at least 70%
after 500 cycles.
The BA001 battery must not be
stowed away if the charge level is
less than 25% or more than 75%.
Before stowing the battery away,
recharge or discharge it so that
13
Publicidad
Tabla de contenido
