Harbor Breeze WO52BB5C Manual Del Usuario página 12

FINAL INSTALLATION
Locate motor screws (J) and lock washers (K) that
6.
were removed in Step 5 on page 7.
Insert two motor screws (J), along with lock
washers (K), through one blade arm (D) to attach
blade arm (D) to motor. Tighten motor screws (J)
securely. (Fig. 6) Repeat with remaining blade
arms (D), making sure to completely secure each
blade arm (D) before proceeding with the next.
7.
Remove three switch housing screws (M) from light
kit fitter (F) and set aside. Then, locate thumb
screws (DD) provided in one of the hardware
packs. Partially insert thumb screws (DD) into
holes in socket covers on light kit fitter (F). (Fig. 7)
Hardware Used
DD Thumb Screw
Re-connect male plug from switch housing to
8.
female plug from light kit fitter (F). Make sure that
the plugs connect tightly. (Fig. 8)
Align holes in switch housing with holes in light kit
fitter (F)--the opening in the top edge of the light kit
fitter (F) should align with the reverse switch for a
secure fit. Attach light kit fitter (F) with the three
switch housing screws (M) that were removed in
the previous step. (Fig. 8)
6
7
M
x12
8
M
Male Plug
Female Plug
12
K
J
F
DD
DD
L
Motor
D
M
DD
Socket
Cover
Reverse
Switch
Switch
Housing
F