Publicidad
Step 8
Carefully turn your unit over onto its front edges. Unfold the
å
BACK (G) and lay it over your unit.
Make equal margins along all four edges of the BACK (G). Push
å
on opposite corners of your unit if needed to make it "square".
Fasten the BACK (G) to your unit using the NAILS (1N).
å
NOTE: Be sure to tap NAILS into the holes that line up over the
å
UPRIGHT (C) and SHELF (E).
NOTE: Perforations have been provided for access through the
å
BACK. Carefully cut out the holes needed.
Push a HIDDEN CAM (1F) into the DRAWER BRACE (M63).
å
Then, insert the metal end of a CAM DOWEL (2F) into the
HIDDEN CAM.
Do not tighten
the HIDDEN CAM
in this step.
www.sauder.com/services
Arrow
Insert the metal end of the CAM
DOWEL into the HIDDEN CAM.
M63
Caution
Do not stand the unit upright without the
BACK fastened. The unit may collapse.
G
Arrow
1F
2F
403681
1N
NAIL
(26 used for the BACK)
These holes must line up over
the UPRIGHT (C) and SHELF (E).
Page 13
Publicidad
