Publicidad
Step 14
To insert the drawer into your unit, line up the EXTENSION SLIDES on the drawer
å
with the EXTENSION RAILS on the unit and push the drawer into the unit until the
drawer is fully inserted. The drawer will push in hard until it is all the way in, then it
will slide in and out easier.
Push the RUBBER SLEEVES (2R) over the METAL PINS (1R). Insert the METAL PINS
å
into the hole locations of your choice in the ENDS (A and B) and UPRIGHT (C). Set
the ADJUSTABLE SHELVES (H) onto the METAL PINS.
Peel two FELT DISCS from the FELT DISC CARD (1M) and stick them on the
å
DRAWER FRONT where it comes into contact with the ENDS (A and B).
www.sauder.com/services
50 lbs.
20 lbs.
H
B
20 lbs.
H
40 lbs. total
C
50 lbs.
403681
(8 used)
2R
A
1R
1M
Page 19
Publicidad
