Publicidad
Step 4
Step
Fasten the END MOLDINGS (S) to the ENDS (A and B). Use
å
four BLACK 9/16" LARGE HEAD SCREWS (1S) through the
METAL BRACKETS and into the END MOLDINGS.
NOTE: The END MOLDINGS should overhang the inside
å
surface of the ENDS. There are no pre-drilled holes in the
END MOLDINGS. The SCREWS will tighten into the grooves.
BLACK 9/16" LARGE HEAD SCREW
(4 used in this step)
The grooves are
closer to this edge.
www.sauder.com/services
1S
A
403681
Remember:
Righty tighty.
Lefty loosey.
These edges should be even.
B
Page 9
Publicidad
