Publicidad
Step 3
Step
Separate the EXTENSION SLIDES (U) from the EXTENSION RAILS (T) as
å
shown in the upper diagram below. Be prepared, the parts are greasy.
Fasten the EXTENSION RAILS (T) to the ENDS (A and B). Use four GOLD
å
5/16" FLAT HEAD SCREWS (3S).
NOTE: For each EXTENSION RAIL, turn a SCREW into the hole shown in
å
the enlarged diagram. Then, slide the inner cartridge of the EXTENSION
RAIL out to fi nd the other hole that lines up with the hole in the END. Turn
a SCREW into this hole.
Fasten six METAL BRACKETS (4G) to the ENDS (A and B). Use six
å
BLACK 9/16" LARGE HEAD SCREWS (1S).
NOTE: Be sure the edges of the METAL BRACKETS are even with the
å
edges of the ENDS.
Push the black lever in and pull the SLIDE from the RAIL.
Unfi nished edge
4G
(6 used)
BLACK 9/16" LARGE HEAD SCREW
(6 used for the METAL BRACKETS)
Page 8
U
T
A
4G
1S
T
Open end
T
B
Unfi nished edge
403681
3S
GOLD 5/16" FLAT HEAD SCREW
(4 used for the RAILS)
Use this hole.
www.sauder.com/services
Publicidad
