Behind The Refrigerator; Preparing For Vacation; Preparing To Move; Replacing The Light Bulbs - GE PZS22MMKES Manual Del Propietario E Instrucciones De Instalación

Care and Cleaning

Behind the Refrigerator

Be careful when moving the refrigerator away from
the wall. All types of floor coverings can be damaged,
particularly cushioned coverings and those with
embossed surfaces.
Pull the refrigerator straight out and return it to position
by pushing it straight in. Moving the refrigerator in a side
direction may result in damage to the floor covering or
refrigerator.

Preparing for Vacation

unplug the refrigerator. Clean the interior with a baking
soda solution of one tablespoon (15 ml) of baking soda
to one quart (1 liter) of water. Leave the doors open.
Set the icemaker power switch to the O
and shut off the water supply to the refrigerator.

Preparing to Move

Secure all loose items such as shelves and drawers by
taping them securely in place to prevent damage.
When using a hand truck to move the refrigerator, do not
rest the front or back of the refrigerator against the hand
truck. This could damage the refrigerator. Handle only
from the sides of the refrigerator.

Replacing the Light Bulbs

WARNING
Before replacing a burned-out light bulb, the refrigerator should be unplugged in order to avoid
contact with a live wire filament. (A burned-out light bulb may break when being replaced.)
Refrigerator Compartment—Upper Light
1. Unplug the refrigerator.
2. The bulbs are located at the top of the compartment,
inside the light shield. On some models, a screw at
the front of the light shield will have to be removed.
On other models, the screw is located in the pocket
located at the back of the shield.
3. To remove the light shield, on some models, press in
on the tabs on the sides of the shield and slide forward
and out. On other models, just slide the shield forward
and out.
22
When pushing the refrigerator back, make sure you
don't roll over the power cord or icemaker supply line (on
some models).
qualified servicer drain the water supply system (on
some models) to prevent serious property damage due
to flooding.
Be sure the refrigerator stays in an upright position
during moving.
(on some models)
4. After replacing the bulb with an appliance bulb of the
5. Plug the refrigerator back in.
same or lower wattage, replace the light shield and
screw. When replacing the light shield, make sure
that the tabs at the back of the shield fit into the slots
at the back of the light shield housing.
Your light shield will look like one of the following:
OR
Tabs
Pocket
49-60647 Rev. 8