Polaris 3900 Instrucciones De Instalación página 6

Page 6
ENGLISH
1
Figure 23. Replace three (3) bottom housing
screws
10. Replace the hubcap on single side wheel. Press
until it snaps into place.
11. Replace the tire on single side wheel. Thread the
lip of the tire around the bottom of the wheel and
work tire gradually around the wheel. Ensure the
lips on both sides of the tire are fully threaded over
the outside of the wheel.
12. Turn cleaner over onto single side wheel. Replace
wheels on the double wheel side. Insert the keyed
side of wheel into the wheel sprocket assembly.
13. Rotate the wheel bearing to align hexagonal notch
with the shaft. Press the bearing down firmly.
(Figure 24.)
(A)
Figure 24. (A) Rotate bearing to align wheel shaft.
(B) Press wheel bearing down.
Polaris 3900 Tune Up Kit
®
2
3
(B)
|
Installation Instructions
14. Replace screws in center of each wheel.
15. Replace the two (2) wheel hubcaps by snapping
into place.
16. Reconnect the cleaner bag (Figure 25).
Figure 25. Connect cleaner bag
17. Reconnect the sweep hose (Figure 26).
Figure 26. Connect sweep hose