Before You Begin; Tools And Materials - Mirabelle GALATIA MIRGA241 Instrucciones De Instalación

• Carefully inspect the new toilet for damage.
• Carefully inspect the new toilet for damage.
• If the existing toilet does not have a supply
• If the existing toilet does not have a supply
shut-off valve below the tank, install one
shut-off valve below the tank, install one
before installing the new toilet.
before installing the new toilet.
To ensure this product is installed properly, please read these instructions carefully before you begin.
(Certain installations may require professional help.) Also be sure your installation conforms to local
codes.
TO AVOID BREAKAGE AND POSSIBLE INJURY HANDLE WITH CARE!
NOTE: Pictures may not exactly define contour of china and components.
REMOVE OLD TOILET
a. Close toilet supply valve and flush tank completely.
Towel or sponge remaining water from tank and bowl.
b. Disconnect and remove supply line.
10 " Adjustable wrench
NOTE: If replacing valve, first shut off main water supply!
c. Remove old mounting hardware, remove toilet and plug floor waste opening to prevent escaping
sewer gases.
d. Remove closet bolts from flange and clean away old wax, putty, etc. from base area.
NOTE: Mounting surface must be clean and level before new toilet is installed!
Supply shut-off valve
PARTS INCLUDED FOR INSTALLATION
Tape measure
4" Drain
Adapter
Level
Expansion
Bolts

BEFORE YOU BEGIN

BEFORE YOU BEGIN

TOOLS AND MATERIALS

CAUTION: PRODUCT IS FRAGILE.
Sponge
Wax seal
5/16" Bolts w/nuts and
washers
Putty knife
1
1
CAUTION
Risk of personal injury or
product damage.
Handle with care. Vitreous china can break
or chip if the product is handled carelessly.
1/2" Nut driver/socket
Screwdriver
Hacksaw
3" Drain
Adapter
Mounting
Bolts &
Washers