Sauder 418299 Manual Del Usuario página 12

Step 7 Step
Separate the EXTENSION SLIDES (Y) from the EXTENSION
å
RAILS (X) as shown in the upper diagram below. Be prepared, the
parts are greasy.
Flip the LEFT UPRIGHT (D) over so the TWIST-LOCK® FASTENERS
å
are facing up.
Fasten the EXTENSION RAILS (X) to the LEFT END (B) and LEFT
å
UPRIGHT (D). Use four GOLD 5/16" FLAT HEAD SCREWS (3S).
NOTE: For each EXTENSION RAIL, turn a SCREW into the hole
å
shown in the enlarged diagram. Then, slide the inner cartridge of the
EXTENSION RAIL in or out to fi nd the other hole that lines up with
the hole in the END and UPRIGHT. Turn a SCREW into this hole.
Open end
Page 12
Y
Push the black lever in and pull the SLIDE from the RAIL.
B
X
D
418299
X
X
3S
GOLD 5/16" FLAT HEAD SCREW
(4 used in this step)
www.sauder.com/services
Open end