Black 1-1/8" Machine Screw - Sauder 418299 Manual Del Usuario

Step Step 20
Carefully stand your unit upright.
å
Push the DOOR STOP (4I) into the hole in the
å
RIGHT UPRIGHT (C).
Before fastening the DOOR to your unit, be sure the
å
mounting screw is against the stops as shown in the right
diagram. If it isn't, loosen the mounting screw to slide it
against the stops. Then tighten the mounting screw.
Fasten the DOOR (K) to the RIGHT END (A) as shown in
å
the lower diagram. Use the screws in the HINGES. You
should start each SCREW a few turns before completely
tightening any of them.
Fasten a KNOB (69K) to the DOOR (K). Use the BLACK
å
1-1/8" MACHINE SCREW (21S).
See the next step for DOOR adjustments.
å
www.sauder.com/services
Stop
Mounting
screw
C

BLACK 1-1/8" MACHINE SCREW

418299
Pro Tip: Lift with your
legs. And, you know,
your arms.
Hinge
4I
A
K
21S
(1 used in this step)
Page 25
69K