Publicidad
Step 10
Carefully turn your unit over onto its front edges. Unfold the
å
BACK (E) and lay it over your unit.
Make equal margins along along the two short edges and along
å
the two long edges of the BACK (E). Push on opposite corners of
your unit if needed to make it "square".
Fasten the BACK (E) to your unit using the NAILS (1N).
å
NOTE: Be sure to tap NAILS into the holes that line up over the
å
SHELF/BOTTOM (D).
These holes must line up over
the SHELF/BOTTOM (D).
www.sauder.com/services
Caution
Do not stand the unit upright without the
BACK fastened. The unit may collapse.
(43 used in this step)
E
409934
1N
NAIL
Page 15
Publicidad
