Publicidad
Step 12
Carefully stand your unit upright.
å
Before fastening the DOOR to your unit, be sure the
å
mounting screw is against the stops as shown in the
diagram. If it isn't, loosen the mounting screw to slide it
against the stops. Then tighten the mounting screw.
Fasten a DOOR (F) to the LEFT END (B) as shown in
å
the lower diagram. Use the screws in the HINGES. You
should start each SCREW a few turns before completely
tightening any of them.
Fasten a KNOB (24K) to the DOOR (F). Use a BLACK
å
1-1/8" MACHINE SCREW (21S).
Repeat this step for the other DOOR (F).
å
See the next step for DOOR adjustments.
å
Hinge
www.sauder.com/services
24K
Stop
Mounting
screw
21S
BLACK 1-1/8" MACHINE SCREW
(2 used for the KNOBS)
B
F
409934
Want options? Customize
your item with add-on
hardware kits available
on sauder.com.
Page 17
Publicidad
