TEFAL Masterchef Gourmet Manual Del Usuario página 9

SM_KITCHEN-MACHINE-MC-GOURMET_MOUFAL_8080013263_OK_EST 06/12/13 14:22 Page13
ACCESSORIES USED :
- Blender jug (d)
2.1 - ASSEMBLING THE ACCESSORIES
• Place the multi-function head (a3) in the horizontal position: press the button (a2) and manually
lower the multi-function head (a3) until it locks (the button (a2) returns to its initial position).
• Unlock the safety cover (a5) from the high-speed outlet (a4) by rotating it anti-clockwise and then
remove it.
• Make sure that the appliance is switched off before locking the blender (d).
• Lock the blender jug (d) on the outlet (a4) by rotating it clockwise.
• Place the food in the blender jug, and lock the lid (d2) fitted with the measuring cap (d3), by rotating
it anti-clockwise.
2.2 - USAGE
• Start by turning the selector button (a1) to the desired position according to the recipe.
Use the "Pulse" position for better mixing control and for a better blending of your preparation.
You can add food through the hole in the measuring cap (d3) during preparation.
• To stop the appliance, turn the button (a1) to "0".
Tips :
You can prepare:
- finely blended soups, cream soups, stewed fruit, milkshakes and cocktails.
- liquid batter (pancake, fritters, Yorkshire pudding, waffles, clafoutis and custard flans).
If ingredients stick to the sides of the bowl when mixing, stop the appliance. Remove the blender, and
push the food down onto the blades and put your blender back to continue your preparation.
• Never fill the blender jug with boiling liquid. Only use liquids or foods at simmering temperatures or
below.
• Never run the blender jug empty.
• Always use the blender jug with its lid.
• Never remove the lid before the blades have stopped completely.
• Always pour liquid ingredients into the blender jug first before adding solid ingredients.
2.3 - DISMANTLING THE ACCESSORY
• Wait for the appliance to come to a complete stop before removing the blender by unlocking it in the
anti-clockwise direction and put back the cover (a5) by locking it on the outlet (a4) (clockwise).
3 - MINCING
(DEPENDING ON MODEL)
ACCESSORIES USED :
- Attachment holder (e)
- Assembled mincer head (f)
3.1 - FITTING THE MINCER ATTACHMENT
• Press the button (a2) to release the multi-function head (a3) and raise it until it locks in place.
• Place the attachment (e) and lock it in the anti-clockwise direction such that the outlet is in alignment
with the appliance.
• Place the multi-function head (a3) in the horizontal position by pressing the button (a2) once again.
3.2 - ASSEMBLING THE MINCER HEAD
• Hold the body (f1) by the feed tube, with the wider opening uppermost.
• Insert the feed screw (f2) (long shaft first) into the body (f1).
• Fit the blade (f3) onto the short shaft protruding from the feed screw (f2) with the cutting edges facing
outwards.
• Fit the chosen screen (f4 or f5) on the blade (f3), aligning the two lugs with the two notches in the
body (f1).
• Screw the nut (f6) home on the body (f1) in the clockwise direction, without locking it.
13
EN