Russell Hobbs 22700-56 Manual De Instrucciones página 4

2. Put the sieve into the separator and press it down onto the drive shaft.
3. Line up the * on the lid with the ) on the motor base. Turn the separator clockwise to
line up the * with the (.
4. Fit the pulp container under the left hand side of the lid.
5. Put the multi-purpose jar under the spout to collect the juice.
6. Fit the pusher into the tube.
USING
1. Check that the appliance is switched off (O).
2. Put the plug into the power socket.
3. Turn the appliance on (I).
4. Remove the pusher and drop the ingredients down the tube.
5. The tube is wide enough for most whole fruits and vegetables but larger ingredients may
need to be cut to fit.
6. Replace the pusher and use it to push the ingredients gently down the tube.
7. Once finished, turn off your juicer (O).
8. The spout can be turned to face upwards to prevent dripping when you have finished
using the appliance.
9. You can fit the resealable top to the multi-purpose jar if desired for storage or to use the jar
as a drinking bottle.
TIPS
• Buy organically grown produce whenever you can.
• Remove stones from fruit like peaches, plums, mangoes, etc.
• Use good quality, fresh, ripe fruit and vegetables. Soft vegetables or overripe fruit can
make the juice thick and cloudy.
• Wash all fruit and vegetables. Use a brush on the harder ones. Remove the outer leaves on
non-organic produce. Peel any non-organic or waxed fruit or vegetables. Cut out and
discard bruises and blemishes as these may affect the taste of the juice.
• Don't juice anything strong or pungent, like onions or garlic. No matter how well you clean
your juicer, you'll never get rid of the taste.
• Bunch up leafy greens, parsley, wheat grass and beansprouts into a small tight ball and
push it down the tube with the pusher.
WARNING!
Rhubarb leaves are poisonous, they contain oxalic acid. They mustn't be juiced or
eaten.
CITRUS PRESS
(FIG B)
The citrus press attachment can be used to press juice out of oranges, grapefruit, lemons, limes,
etc.
ASSEMBLY
1. Fit the coupling onto the drive shaft.
2. Line up the * on the citrus separator with the ) on the motor base. Turn the
separator clockwise to line up the * with the (.
3. Fit the the cone onto the coupling.
4. Put the multi-purpose jar under the spout to collect the juice.
USING
1. Check that the appliance is switched off (O).
2. Put the plug into the power socket.
3. Turn the appliance on (I).
4. Using one half-fruit at a time, place the cut (flesh) side on top of the cone and press it
down.
5. Once finished, turn off your juicer (O).
4