Philips NORELCO QUADRA 7 7867XL Manual Del Usuario página 8

10 ENGLISH
4 Remove and clean one set of heads at a
time.
C
5 Separate the cutter from the comb and
rinse clean under hot water.
◗ Do not clean more than one cutter and comb
at a time, since they are all matching sets. If you
accidentally interchange the cutters and combs,
it could take several weeks before optimal
shaving performance is restored.
C
6
Replace the set back into the Head
Assembly in such a way that the sides with
the little holes point to the middle of the
shaving unit.
◗ Make sure that the two pointy edges of the
head fit exactly into the recesses.
7 Repeat the process for the other two sets
of cutters and combs.
8
Replace the frame.
C
9
Press down and turn wheel clockwise until
it locks into place.
10 Replace the Razor Head Assembly back on
razor.
◗ If the razor heads have been properly inserted,
a shiny circle is visible in the middle of the razor
head assembly.
Once A Month: Razor Heads
◗ For optimum performance, razor cutters and
combs should be cleaned in a degreasing liquid
(e.g. Norelco Razor Cleaner, Model RC1776, or
alcohol) and lubricated with Norelco Razor
Lubricant, model AL80, or one drop of mineral
oil (in the center of the head).
Every Six Months:Trimmer
1 Turn razor OFF.
2 Push Trimmer Slide Switch up to pop up
Trimmer.
C
3 Clean Trimmer with the brush.
C
4 Lubricate the Trimmer teeth with Norelco
Razor Lubricant (model AL80) or with one
drop of mineral oil.
5 Close Trimmer by sliding Trimmer switch
down.
This razor has no other user-serviceable parts.
Any other service should be performed by an
Authorized Norelco Service Location.
ENGLISH 11