Oster VERSA Guia De Inicio Rapido

Blending Hints & Tips
OSTER
®
VERSA PERFORMANCE
®
BLENDER
The Power to Blend Everything
BLSTVB-RV0-000_13ESQSG1.indd 1
Congratulations on the purchase of your new Oster
but please read all the instructions in the Instruction Manual to ensure proper use and performance.
If you have any comments, questions or inquiries about this revolutionary product, please call 1-800-334-0759.
Getting Started
Before you get started, separate the tamper, lid, filler cap, and jar. Wash in warm, soapy water. Rinse and dry well.
Unit will not operate unless the jar is fully seated on base. Please follow assembly instructions listed below.
Note – Do not put the jar in the dishwasher.
Your Product Features and Assembly
Jar Sensor
The unit is supplied with a jar sensor. This will prevent the motor from starting if the jar
is not properly placed on the base. The control knob must be in the 'Off' position when
the jar is placed on the base.
For your safety, if the jar is removed from the base during blending, the motor will
shut off. This also applies even if slightly lifted unintentionally.
Control Panel
The control panel includes a speed dial, plus 3 programmed settings and pulse. To use
the speed dial, simply turn it clockwise to choose from manual settings from 'Low' to
'High.' To use the programmed settings, you must first activate by turning the speed dial
counter-clockwise to the 'Programmed/Pulse' setting. Then select which programmed
setting you would like to use.
These settings have been optimized by time and speed to best blend most Smoothies,
Soups, and Dips/Spreads. It will stop once the cycle is complete.
When the speed dial is turned to the 'Programmed/Pulse' setting, the red light around the
pulse button will flash to indicate the unit is ready to operate. Avoid contact with blades or
moveable parts. Never operate the unit without the lid in place.
Tamper
The unit comes equipped with a tamper. This allows you to accelerate the process of very
thick and/or frozen mixtures. If food is not circulating, remove the filler cap and use the
tamper to press ingredients down into the blades.
Fuse/Overload Protection
If the unit stops working, the fuse/overload protection has kicked in. First turn speed dial
to 'Off' and unplug from the electrical outlet. Then, remove the jar from the base and free
the blade of any food obstructions. Wait 30-45 minutes for the unit to cool and then it
will be ready to use again. Next, press the external resettable fuse on the bottom on the
base.
Note – Due to the power of the machine, it is normal for it to be fairly loud during operation.
© 2013 Sunbeam Products, Inc. doing business as Jarden Consumer Solutions Boca Raton, Florida 33431.
All rights reserved. P.N. 166825
NOTE: For safety information, read the Important Safeguards in the user manual.
* This Guide is not a substitute for the Owner's Manual. Refer to this guide only after you have read the
Owner's Manual thoroughly.
Visit www.osterversa.com to find your blender's owner's manual.
Versa Performance Blender! Here are a few quick tips to get you started,
® ®
GCDS-OST29332-JC
Flashing
Lights
Pulse
Tamper
Jar Sensor
Speed Dial
Programmed
Settings
LED Lights
5/21/13 8:45 AM