Using The Rotary Commander - Sony CDX-C4850R Manual De Instrucciones

Using the rotary
commander
The rotary commander works by pressing
buttons and/or rotating controls.
CDX-C4850R/C4840R only:
You can also control optional CD or MD units
with the rotary commander.
By pressing buttons
(the SOURCE and MODE buttons)
(SOURCE)
Each time you press (SOURCE), the
source changes as follows:
TUNER n CD n MD*
* If the corresponding optional equipment is
not connected, this item will not appear.
(CDX-C4850R/C4840R only)
Pressing (MODE) changes the operation
in the following ways;
• Tuner: FM1 n FM2 n MW n LW
• CD unit: CD1 n CD2 n ...
• MD unit: MD1 n MD2 n ...
By rotating the control
(the SEEK/AMS control)
Rotate the control momentarily and
release it to:
•Locate a specific track on a disc. Rotate
•Tune in stations automatically. Rotate and
(MODE)
By pushing in and rotating the
control (the PRESET/DISC control)
Push in and rotate the control to:
•Receive the stations memorised on the
•Change the disc. (CDX-C4850R/C4840R
and hold the control until you locate the
specific point in a track, then release it to
start playback.
hold the control to find a specific station.
number buttons.
only)
17