TESY HL-245VB Manual Del Usuario página 5

Detach the up-hook from the back of the appliance
4.
and put it in the position of the 5 pegs at the
bottom. Fix the up-hook on wall with 5 ST4X30
screws.
Hang the appliance on wall with a ST4X30 screw on
5.
the peg above.
Tighten 4 M6X18 screws on the right side and one
6.
ST4X18 screw on the left side to fix the appliance.
x2
English
x5
x1
x2 x1
INSTRUCTION FOR USE
Push the ON/OFF (0/I) button located at the back of the
appliance to switch on the appliance. Push again, if you
want to switch off.
Set date and time:
The date and time setting can be done only when the
appliance is in standby mode.
Press SET, the day icon 1 2 3 4 5 6 7 flashes. Use +
and - to set current day. Then press OK, the hour icon
flashes. Use + and – to set hour. Then press
OK, the minute icon
minute. In the end, press OK to confirm and finish day
and time setting.
Switch mode:
Press MODE, to switch mode:
•
OFF/OFF shows under the day icon = manual mode;
•
shows and in the same time, wake up time shows
under the day icon = program mode.
Manual mode:
When the appliance is in standby mode, press F to start it.
•
Press F once, the heater will run with 2000W power (
shows on the screen);
•
Press F for the second time, the heater will run with
1000W power ( shows on the screen).
•
Press F for the third time, the appliance will run in
the fan mode ( shows on the screen)
•
Press F for the fourth time, the appliance will stop in
15 seconds.
•
When the appliance is running, press SET, the icon
of the temperature SET flashes. Use + and – to set
the target temperature.
Note:
The temperature SET should be higher than the
1.
room temperature (the temperature icon on the
left). Otherwise, the appliance will not start heating.
One the room temperature achieves the target
2.
temperature, the appliance will stop automatically.
If the room temperature is 3°C less than
3.
temperature SET, the appliance will restart.
flashes. Use + and – to set
Usage and Storage Instructions
EN
5