Overheating Protection - TESY HL-245VB Manual Del Usuario

Program mode:
EN
Set wake up time and temperature:
In standby mode, long press
flashes. This means that you are setting the wake up
time and temperature for week-days.
The hour icon
+ and – to set hour. Press OK, the minute icon
flashes. Use + and – to set minute. Then, press OK
to confirm the wake up time for week-days and the
temperature SET flashes. Use + and – to set target wake
up temperature.
(During the setting, you can press SET to activate/shut
down the wake up program for week-days.)
Then press OK to move on to wake up time and
temperature setting for week-ends. 6 7 flashes. This
means that you are setting the wake up time and
temperature for week-ends.
In the same way, you can set the wake up time and
temperature for week-ends.
(During the setting, you can press SET to activate/shut
down the wake up program for week-ends.)
In the end, press OK to confirm and end the setting. All
icons will stop flashing.
Note:
In program mode, the heater starts working at
1.
wake-up time for 15 minutes. If no presence of
people is detected by the sensor located at the front
of the appliance, the appliance will stop heating. If
the presence of people is detected, the heater will
keep working for an extra 15 minutes.
In program mode, the heater can only run with
2.
2000W.
In program mode,when working, the setting wake-up
3.
timeflashes and the icon
Towel heating:
Press , to start towel heating. Press
towel heating. The towel will stop automatically after
two hours if you don't turn it off manually.
(The towel heating cannot be turned on if the hanger is
folded up.)
Note: The maximum weightbearing for towel should
less than 2kg/bar(6 kg in total for 3 bars)
FILTER CLEAN
Filter becomes dirty during use, or after 30 hours usage,
the indication
Press OK, sounds stop while
off, then remove the filter on the back of the appliance.
Clean the filter directly under water. Do not use caustic or
abrasive material during cleaning, as this can damage the
6
Usage and Storage Instructions
for 3 seconds, 1 2 3 4 5
under 1 2 3 4 5 flashes. Use
not shown at the screen.
, again to stop
flashes with sounds "BE, BE, BE...".
flash. Turn the appliance
filter. Then, have the filter dried naturally.
The machine can'twork until
take around 15 minutes.
Then reassemble the filter according to the reference
line(see below drawing).
Push the filter to the end until it cannot move anymore.

OVERHEATING PROTECTION

The in-built overheating protection automatically turns
the appliance off in case of an error! In that situation
the plug must be disconnected from the mains and the
control switch put in position "0". After a short period of
cooling the appliance is ready for operation (in about
10-15 minutes)! If that error is repeated – consult an
authorized service at your location!
CLEANING
•
You must first turn off the appliance and disconnect
its plug from the socket. Do not use abrasive
detergents!
•
Clean the body with wet cloth, vacuum cleaner or
a brush!
•
You must never submerge the appliance under
water – there is life danger!
•
If the appliance should not be used for a certain
period of time it must be secured from excessive
dirt and dust by placing it in its original package.
•
You must never place the hot appliance in its
package!
Warning: in order to avoid
overheating do not cover the appliance!
Instructions for environment protection
Electric appliances out of use contain valuable
materials and hence must not be disposed in
domestic dumbs! We kindly ask you for cooperation
and active role in preservation of natural resources by
disposing the appliance to the organized buy-back
locations (if there are any).
disappear, which will