Festo CPX-CMPX-C-1-H1 Manual De Instrucciones página 12

3.2 Pin assignment of axis connection
X
3.3 Note on replacing the CMPX module
Caution
Faults in the system structure and incorrectly set para
meters can cause the drive to move to an end position
uncushioned. The fixed stop or the drive may then be
damaged. You must observe the following instructions
in order to prevent such collisions.
The parametrizing and the taught positions are saved in
the CMPX module. Therefore, check the parameters when
a CMPX module has been replaced and, if necessary, carry
out commissioning again. See System Manual for the
CMPX.
12
Pin Assignment
1 + 24 V logic voltage
2 + 24 V load voltage
3 0 V
4 CAN_H
5 CAN_L
Housing Cable screening/shield
Festo CMPX−C−1−H1 0802NH English