CAUTION! Risk of burns through hot machine surface! During
the laminating process, the machine surface heats up. Do not
touch the machine surface during the laminating operation.
Wait a few minutes after laminating until the laminator has
cooled down before you touch it.
CAUTION! Risk of burns through hot laminating pouch. When
the laminating pouch is ejected after lamination, it is extremely
hot. Only remove the ejected lamination pouch holding it at the
cooled end.
CAUTION! Risk of burns through hot residual laminated
material. After cleaning, very hot residual laminated material is
stuck to the ejected paper. Only remove the ejected paper
holding it at the cooled end.
CAUTION! Risk of tripping through improperly laid cable. Lay
cables in such a way that nobody can trip over them. Make
sure the power plug and cable cannot be damaged. Ensure that
the laminator is set up near an easily accessible power socket
so that it can be disconnected from the power supply in an
emergency.
ATTENTION! Risk of property damage. Avoid exposing the
laminator to environmental influences such as smoke, dust, vibra-
tion, chemicals, moisture, heat or direct sunlight. Only use the
laminator in indoor areas and within the ambient conditions
permitted and stipulated in "Technical Data".
G
For Your Safety
15