Regular Maintenance And Service - Olympia A 6040 Manual De Instrucciones

Regular Maintenance and Service

Clean the laminator at regular intervals.
1. Before cleaning, disconnect the
2. Wait until the laminator has cooled down. Information on cooling
down times is provided in Section Technical Data.
NOTE Risk of damage to the laminator through aggressive cleaning
agents. Do not use any solvents or cleaning agents.
3. Use a soft, damp and lint-free cloth to clean the surface of the lamina-
tor.
Removing Deposits and Residual Adhesive
Adhesive and other residues on the rollers can impair the lamination re-
sult. Remove these at regular intervals and whenever the lamination result
is not as good as expected.
1. Switch the
power switch
5 lights up red.
switch
CAUTION! Risk of burns through hot machine surface! During
the laminating process, the machine surface heats up. Do not
touch the machine surface during the laminating operation.
Wait a few minutes after laminating until the laminator has
cooled down before you touch it.
2. Fold a sheet of paper and feed it into the
with the folded edge first and keeping it straight. Residual adhesive is
removed and taken up by the paper when ejected.
CAUTION! Risk of burns through hot residual laminated
material. When the paper is ejected after the cleaning process,
it can contain hot residual material. Only remove the ejected
paper holding it at the cooled end.
3. Repeat the process with a new sheet of paper until the paper comes
out clean.
Regular Maintenance and Service
power plug
to ON, the control lamp on the
5
infeed
G
.
4
power
of the laminator
9
21